Most fence posts need to sit about one-third of their total length in the ground, so a 6-foot fence section typically calls for a post set 24 to 30 inches deep. In Louisiana’s soft, wet, high-water-table soil, installers usually push toward the deeper end of that range and use a wider hole with more concrete, since shallow posts are far more likely to lean or shift after heavy rain. Corner, end, and gate posts need extra depth beyond that baseline because they carry more load than the line posts in between.
A fence is only as good as what is holding it up. You can pick the best wood, vinyl, or aluminum on the market and still end up with a leaning fence line a year later if the posts were not set deep enough. In South Louisiana, post depth matters more than almost anywhere, because the ground under a metro-area yard behaves nothing like the firm soil national depth charts assume. The TurnKey Fences crew sets posts across the area every week, and this guide covers the depth math and the setting methods that keep posts straight.
The One-Third Rule for Fence Post Depth

The rule most installers start from is simple: roughly a third of the post’s total length goes into the ground, leaving two-thirds above grade. A post cut for a 6-foot fence is usually a 9 or 10-foot length, with about a third buried and the rest trimmed to height once it is set and the concrete has cured.
That one-third figure is a starting point, not a hard ceiling. It works well on firm, well-drained soil. On soil that holds water the way ours does, most installers add a few extra inches of depth as a buffer against movement, especially on taller or heavier fence sections.
Post Depth by Fence Height
The table below shows general depth guidance by fence height. Treat it as planning information, since exact depth also depends on post material, soil conditions on your specific lot, and whether a post is a line post or a corner, end, or gate post.
| Fence height | General post depth | Typical hole diameter |
|---|---|---|
| 3 to 4 ft (picket, decorative) | 16 to 20 inches | 8 inches |
| 5 ft | 20 to 24 inches | 8 to 10 inches |
| 6 ft privacy or ornamental | 24 to 30 inches | 10 to 12 inches |
| 7 to 8 ft privacy or screening | 30 to 36 inches or more | 12 inches |
Corner posts, end posts, and gate posts typically need to go a few inches deeper and into a wider hole than the line posts along a straight run, since they absorb most of the pulling and racking force whenever a gate swings or a fence panel flexes in the wind.
Why Louisiana Soil Changes the Math

Most fence-depth charts are written for soil that drains well and stays stable year-round. New Orleans-area soil does neither. It is soft, fine-grained, and sits over a water table that can be just a few feet below the surface, so the ground around a post is often damp long after the rain stops. Soil that holds that much moisture gives a post far less resistance to leaning than firm, sandy ground does.
That is the main reason local installers lean toward the deeper end of the standard depth ranges and use a wider hole than a drier-climate chart would call for. More depth and more hole diameter mean more concrete surrounding the post, which spreads the load over a bigger footprint of soil and gives the post far more resistance to shifting as the ground swells and contracts through our wet and dry stretches.
Post Hole Diameter Matters As Much As Depth
A hole that is too narrow is a common shortcut on a fence job, and it causes problems even when the depth is right. As a general guideline, the hole diameter should run about three times the post width, so a standard 4-by-4 post calls for a hole around 10 to 12 inches across. A narrow hole leaves only a thin concrete collar, giving soft soil an easy opening to push the post off plumb.
Concrete Versus Gravel-Set Posts
Setting a post in poured concrete is the standard approach for privacy fences, ornamental fences, and anywhere wind load or soil movement is a real concern. The concrete cures into a rigid collar that locks the post in place and resists the lateral pressure soft soil puts on it.
Gravel-set posts, where compacted gravel replaces concrete, are sometimes used for lighter or temporary fencing, since gravel drains well. On its own, though, it offers far less resistance to movement, which is why it rarely suits a privacy or ornamental fence here. Most installers combine the two: gravel at the base for drainage, with c